Drilled Piers and Caissons for commercial projects
When the ground near the surface cannot carry a building, loads are taken down through drilled shafts to rock or dense soil. We auger the hole, set the cage and place the concrete in one continuous operation.

Typical drilled Piers and Caissons jobs
- Pier foundations for tilt-up and steel-frame buildings
- Caissons under columns, canopies and signs
- Shafts through fill or soft clay to bear on rock
- Pole, light and sign foundations drilled to depth
The numbers
- Typical shaft diameter18 to 48 in
- Mix4,000 psi, 6 to 8 in slump so it flows around the cage
- PlacementContinuous, to avoid cold joints in the shaft
The drilled Piers and Caissons process, step by step
- 1
Layout and drilling to the design diameter and depth, with the bottom cleaned
- 2
Reinforcing cage lowered, centered and held at the top
- 3
Concrete placed by tremie or drop chute in one continuous pour
- 4
Tops finished to elevation and inspected, then capped or tied to grade beams
Drilled Piers and Caissons in your city
Pick your city for the frost depth, ground and pour season that shape the work there.
Or browse every city
Nashville and Davidson County
Williamson and Maury Counties
Rutherford, Wilson and Sumner Counties
Middle and East Tennessee
The Southeast
Northeast and Mid-Atlantic
The Midwest
Texas and Oklahoma
Often ordered with this
Structure and FoundationsFoundation Walls and FootingsFootings and walls that carry the whole building
Structure and FoundationsSlab on GradeThe floor slab that everything else sits on
Structure and FoundationsElevated Slabs and DecksStructural floors poured above ground
Structure and FoundationsConcrete Columns and BeamsCast-in-place frames that stand up to the load
Structure and FoundationsShear Walls and Core WallsWalls that brace tall buildings against wind and quakes
Structure and FoundationsTilt-Up Concrete WallsWall panels cast flat and lifted into placeNo service matches that search. Try a shorter word.
Drilled Piers and Caissons: straight answers
Why are piers drilled instead of dug?
A drilled shaft reaches deeper than an open footing, passes through weak soil and bears on rock or dense layers, so the building does not settle.
What happens if water enters the hole?
The shaft is pumped or cased, and concrete is placed from the bottom with a tremie so it pushes the water out instead of mixing with it.
Who designs the structural concrete?
The project's structural engineer designs the sizes, steel and strength. We build to those drawings, and we point out buildability issues early so changes are made on paper, not in the field.
Do you do drilled Piers and Caissons in my city?
Most likely. Commercial Crete serves cities across the country, and every city has its own page. Use the map, pick your city below or call (800) 290-5816 and tell us where the project is.
Get a bid for drilled Piers and Caissons
Tell us about the project: the city, the kind of concrete work and when you need it. You get a plain written bid, and a person answers the phone at (800) 290-5816.